Twin bedroom sets allows you to add extra sleeping space without allocating an entire room to a guest bed. A trundle bed is also a good complement to a child’s room. Tristan Slides under another bed for practical storage until needed. Make sure the bed you plan to store the trunk under holds the height of a double mattress plus the height of the wheels. Consider adding the bed risers to the single bed if you need extra height. Plywood should be 40 inches wide and 76 inches long to accommodate a Standard Twin mattress. Have worked at home improvement store if you do not have a circular saw at home.
Sand the edges of twin bedroom sets with fine sandpaper until they are soft and smooth. Cut two pieces of trim casting to 40 inches long. Cut ends at a 45 degree angle so that they fit around the edges of the truss as a frame. Select a list that is at least 1 cm wide so it will hold the mattress in place on the tress. Cut two pieces of trim casting 76 inches long with a good 45 degree angle. Sand the ends of all four pieces of trim easily to smooth out uneven edges. Apply the thigh on the inside of a piece of trim. Place the trim on the edge of the plywood and clamp it with plywood with woodworking clamps. Repeat with the other three pieces of trim.
Hammer finish nails through trim and in plywood base. Apply wood to any gaps or visible seams on the trim forming corner or where it attaches with plywood. Let the wood dry. Turn the trunk frame over and set the wheels on the underside. Select the places where you will attach wheels with screws. Place the wheels on the bottom and slide the screws through the holes in the wheels and the holes in the plywood. Hold the handle with one hand and bolts tighten the other end of the screws. Paint the twin bedroom sets frame with interior latex paint. Apply 2-3 thin layers of paint so that each layer dries before next. Allow the final paint layer to dry thoroughly. Place the mattress on the trundle bed frame.